The only expansion control products with co-extruded technology to give you twice the movement of zinc and provide superior expansion control.

Description

For Stucco and Plaster Control joints provide relief of stresses to the surface coating caused by building movement, environmental conditions or construction stress points. The design professional or architect – not the applicator – shall determine the location of control joints. Installation and attachment shall be in accordance with ASTM C1063, ASTM C926, ASTM D1784, the Portland Cement Plaster (stucco) Manual, local building codes, and industry standards. The use of control joints does not guarantee that cracks will not occur in the stucco coating.

Small Boss Specification

To install

Cut control joint to fit design detail. Attach to substrate with specified fastener or tie wire to lath every 6 to 8 inches.
All lath applications shall be cut at the control joint, then attached to each side to create independent panels. Do not run lath continuously through a control joint application. If a moisture barrier is used, it shall be lapped and continue unbroken behind the component.

(Option) It is recommended not to locate horizontal butt joints over windows, doors, or other openings in the wall(s). Connector clips help to align control joints and provide a surface area for
caulking butt joints in continuous installations. Fully embed adjoining lengths of trim in caulk 

Vertical applications should be maintained and uninterrupted when intersecting with other components. Cut flanges of control joint to create a tight fit with uniform depth in horizontal to vertical butt joints. Embed control joint ends, angles, butts, and intersections in sealant at time of installation

Clean excess coating material from the joint area at time of application. Do not use a trowel to clean the joint area as it may damage or cut the component.